The following list of possible error messages describes common causes and workarounds.
No ISA PnP adapters detected
Cause: The manager did not detect an ISA PnP adapter in your system, either because no adapters are physically present or a physically present adapter is not jumpered into ISA PnP mode.
Solution: Shut down your system, then ensure that the
cards present are seated correctly and jumpered (if necessary)
to support ISA PnP mode.
Verification of HW settings failed
Cause: The settings you specified could not be verified against the settings that have been detected on the adapter. Faulty hardware is the most likely cause.
Solution: Try one or all of the following:
View only mode
Cause: Only the root user is authorized to change resources within the PnP Configuration Manager.
Solution: Exit the manager, log in to the system as root, and restart the manager.
Problem running /sbin/isapnpslot
Cause: This command is run automatically by the manager to extract ISA Plug and Play information about the system. Its failure could be caused by a corrupt binary, incorrect permissions, or a disabled or missing PnP driver. This is an unusual problem.
Solution: Verify the integrity of the binary and that the PnP driver is correctly installed.