DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 
STREAMS polling and multiplexing

Dismantling a multiplexor

Streams connected to a multiplexing driver from above with open, can be dismantled by closing each Stream with close. The mechanism for dismantling Streams that have been linked below a multiplexing driver is less obvious, and is described below.

The I_UNLINK ioctl call disconnects each multiplexor link below a multiplexing driver individually. This command has the form:

ioctl(fd, I_UNLINK, muxid);
where fd is a file descriptor associated with a Stream connected to the multiplexing driver from above, and muxid is the identifier that was returned by I_LINK when a driver was linked below the multiplexor. Each lower driver may be disconnected individually in this way, or a special muxid value of -1 may disconnect all drivers from the multiplexor simultaneously.

In the multiplexing daemon program presented earlier, the multiplexor is never explicitly dismantled because all links associated with a multiplexing driver are automatically dismantled when the controlling Stream associated with that multiplexor is closed. Because the controlling Stream is open to a driver, only the final call of close for that Stream closes it. In this case, the daemon is the only process that opens the controlling Stream, so the multiplexing configuration is dismantled when the daemon exits.

For the automatic dismantling mechanism to work in the multilevel, multiplexed Stream configuration, the controlling Stream for each multiplexor at each level must be linked under the next higher level multiplexor. In the example, the controlling Stream for the IP driver was linked under the TP driver, which resulted in a single controlling Stream for the full, multilevel configuration. Because the multiplexing program relied on closing the controlling Stream to dismantle the multiplexed Stream configuration instead of using explicit I_UNLINK calls, the muxid values returned by I_LINK could be ignored.

An important side-effect of automatic dismantling on the close is that it is not possible for a process to build a multiplexing configuration with I_LINK and then exit. This is because exit closes all files associated with the process, including the controlling Stream. To keep the configuration intact, the process must exist for the life of that multiplexor. That is the motivation for implementing the example as a daemon process.

However, if the process uses persistent links with the I_PLINK ioctl call, the multiplexor configuration remains intact after the process exits. Persistent links are described later in this section.


Next topic: Routing data through a multiplexor
Previous topic: TP multiplexor

© 2004 The SCO Group, Inc. All rights reserved.
UnixWare 7 Release 7.1.4 - 27 April 2004