translate character sets
trchan [-ciko] mapfile
trchan performs mapping as a filter, using the same format of
for mapfile format].
This allows a file consisting of
one internal character set to be translated to another
internal character set.
trchan reads standard input, maps it, and writes to standard output.
A mapfile must be given on the command line.
Errors cause trchan to stop processing unless -c is specified.
The following options can be used with trchan:
causes errors to be echoed on stderr, and processing is continued.
specifies that the input section of the mapfile
is used when translating data.
specifies that the dead and compose sections of the
mapfile are used when translating data.
specifies that the output section of the
mapfile is used when translating data.
options can be specified in any combination;
if none are specified, trchan uses the entire
mapfile, as if all three were specified together.
currently ignores the control sections of the mapfile.
© 2004 The SCO Group, Inc. All rights reserved.
UnixWare 7 Release 7.1.4 - 25 April 2004